I have 2 SCSI U320 hard drives for my server that I am having an issue with.
Both drives, when installed into the server power up, and spin up fine, but, they are not recognized when it comes to trying to configure them.
I would have thought from the documentation that the default configuration would work, but, it does not.
I know the J6 would be the configuration jumper, but, am not up enough on servers to know which SCSI ID to use based upon which position I have it in the chain.
I would also assume that I would need to remove the resistor(s)? The current drives I have in the server do not have configuration jumpers. These are the only 2 in the batch of 10 that came in my lot have have them.
Do these need jumpers for properation?