Scott Mueller's Upgrading and Repairing PCs Forum

Scott on my wifes old PC I have an . I'm trying to figure out how to disable the PXE BOOT. I changed network boot to the last option on the boot order in Cmos. However I still get the PXE boot screen for a few short seconds.

I've downloaded and ran the utility,

https://www.intel.com/content/www/us/en ... ducts.html

From the command prompt in the correct directory I type,

"BOOTUTILW64E -BOOTENABLE=DISABLED -ALL"

I get the error,

"Found discrete rom in the flash for NIC 1.
The -BOOTENABLE command can only be used on flashed combo images."

Here is a description of the commands. I just want to disable PXE so POST doesn't look for it.

https://www.intel.com/content/www/us/en ... ducts.html

I believe you can use the use the to reconfigure the firmware on the card to prevent the Intel Boot Agent from initializing. Let me know how it works, Scott.

Yes that's what I've been trying to do. Now I figured out how to flash the ethernet rom on the card and did that. However I still got that error. So now I'm trying to get back into the configuration by pressing Control S during boot and it goes by so fast I can not get in.

I don't know what's going on but maybe I disabled it somehow or it's disabled by default after a flash. Either way I can't get into the settings during start up anymore. So I guess I ended up doing what I wanted, but now I kind of want to check out the settings and see what's changed with the flash update. So now I'm not sure what to do. I could leave it alone and it'll be fine. This is what I wanted in the first place. However I'm just curious to see if anything changed in the settings.

Nope. I can still see it pop up for just a second or two. It just flashes a version number.

I could keep trying, but it's a pain. Don't know how I can get in or how to time it correctly.